Datasheet Linear Technology RH1085 — Даташит

RH1085
3A Low Dropout Positive
Adjustable Regulator
DESCRIPTION ABSOLUTE MAXIMUM RATINGS The RH1085 positive adjustable regulator is designed to
provide 3A with higher efficiency than currently available
devices. All internal circuitry is designed to operate down
to 1V input-to-output differential and the dropout voltage
is fully specified as a function of load current. Dropout
is guaranteed at a maximum of 1.5V at maximum output
current, decreasing at lower load currents. On-chip trimming adjusts the output voltage to 1%. Current limit is
also trimmed, minimizing the stress on both the regulator
and power source circuitry under overload conditions. (Note 1) The RH1085 is pin compatible with older 3-terminal
regulators. A 10μF output capacitor is required on these
new device. However, this is usually included in most
regulator designs. Power Dissipation . Internally Limited
Input-to-Output Voltage Differential .30V
Operating Junction Temperature Range
Control Section . – 55°C to 150°C
Power Transistor. –55°C to 200°C
Storage Temperature Range.– 65°C to 150°C
Lead Temperature (Soldering, 10 sec) . 300°C PRECONDITIONING
100% Thermal Limit Burn-In
L, LT, LTC, LTM, Linear Technology and the Linear logo are registered trademarks of Linear …

DICE/DWF SPECIFICATION
RH1085MK
3A Low Dropout
Positive Adjustable Regulator
PAD FUNCTION
1. VIN
2. VOUT
3. ADJUST
2 1 DIE CROSS REFERENCE
LTC Finished
Part Number Order DICE CANDIDATE
Part Number Below RH1085MK
RH1085MK RH1085MK DICE
RH1085MK DWF* Please refer to LTC standard product data sheet for
other applicable product information.
*DWF = DICE in wafer form. 1 2
3
2 105.5mils Г— 121mils
Backside metal: Alloyed gold layer.
Connect backside substrate to Pad 2. , LT, LTC and LTM are registered trademarks of Linear Technology Corporation.
All other trademarks are the property of their respective owners. DICE/DWF ELECTRICAL TEST LIMITS
PARAMETER CONDITIONS MIN MAX UNITS Reference Voltage IOUT = 10mA, (VIN – VOUT) = 3V NOTES 1.238 1.262 V 10mA ≤ IOUT ≤ 50mA
1.5V ≤ (VIN – VOUT) ≤ 25V 1.225 1.270 V Line Regulation IOUT = 10mA, 1.5V ≤ (VIN – VOUT) ≤ 15V …